Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009CAMRY HYBRIDREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERSTARTING SYSTEM (HYBRID)
2009 Toyota Camry Hybrid
Starting System (Hybrid)
2009 Toyota Camry HybridSECTION Starting System (Hybrid)
- Smart Key System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- DTC Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- On-Vehicle Inspection
- DTC B2271 Ignition Hold Monitor Malfunction
- DTC B2272 Ignition 1 Monitor Malfunction
- DTC B2273 Ignition 2 Monitor Malfunction
- DTC B2274 ACC Monitor Malfunction
- DTC B2275 STSW Monitor Malfunction
- DTC B2277 Detecting Vehicle Submersion
- DTC B2278 Power Switch Circuit Malfunction
- DTC B2281 "P" Signal Malfunction
- DTC B2282 Vehicle Speed Signal Malfunction; DTC B2283 Vehicle Speed Sensor Malfunction
- DTC B2284 Brake Signal Malfunction
- DTC B2285 Steering Lock Position Signal Circuit Malfunction
- DTC B2286 Runnable Signal Malfunction
- DTC B2287 LIN Communication Master Malfunction
- DTC B2288 Steering Lock Signal Circuit Malfunction
- DTC B2289 Key Collation Waiting Time Over
- Power Switch Indicator Circuit
- Power Source Mode does not Change to ON (IG and ACC)
- Power Source Mode does not Change to ON (IG)
- Power Source Mode does not Change to ON (ACC)
- Power Source Mode does not Change to ON (READY)
- Power Switch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.