Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2022KONA ELECTRIC LIMITEDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLABS/ESC DIAGNOSIS (2 OF 2)
2022 Hyundai Kona Electric Limited
Abs/ESC Diagnosis (2 Of 2)
2022 Hyundai Kona Electric LimitedSECTION Abs/ESC Diagnosis (2 Of 2)
- DTC C160E-08: P-CAN bus off
- DTC C1614-87: CAN Time-Out HCU/VCU/FCU
- DTC C1616-08: C-CAN Bus OFF
- DTC C161C-86: CAN Signal Error HCU/VCU/FCU
- DTC C1623-08: CAN Time-Out Steering Angle Sensor
- DTC C1626-04: Implausible Control
- DTC C1628-08: CAN Time-Out Cluster
- DTC C1638-08: ACC/SCC Communication Error
- DTC C1643-08: CAN Time-Out Yaw Rate & G Sensor
- DTC C1650-08: CAN Signal Error SCC
- DTC C1656-08: CAN Signal Error-Cluster
- DTC C1687-08: CAN Time-Out VSM2 (MDPS)
- DTC C1688-08: VSM2 (MDPS) Signal Error
- DTC C16B6-87: CAN Time-Out AEB
- DTC C16B7-81: CAN Signal Error AEB
- DTC C1702-04: Variant Coding Error
- DTC C1710-55: Assembly-Line Setup Is Still Active
- DTC C1806-87: CAN Time-Out MCU
- DTC C1812-08: CAN Time-Out Gateway
- DTC C1817-08: CAN Signal Error Gateway
- DTC C1818-87: CAN Time-Out LCA/BSD/BCW
- DTC C1825-86: CAN Signal Error-MCU
- DTC C1837-86: CAN Signal Error BCA/BCW
- DTC C1838-87: CAN Time-out RSPA
- DTC C1839-86: CAN Signal Error RSPA
- DTC C2112-01: Valve Relay Error
- DTC C2202-77: Latching Failure/Mechanics
- DTC C2220-74: Rear-LH Actuator
- DTC C2220-71: Rear-LH Actuator (Overcurrent)
- DTC C2220-77: Rear-LH Actuator (Motor stall)
- DTC C2220-94: Rear-LH Actuator (Abnormal Motor Operation)
- DTC C2224-71: Rear-RH (Or Rear) Actuator (Overcurrent)
- DTC C2224-74: Rear-RH (Or Rear) Actuator
- DTC C2224-77: Rear-RH (or rear) Actuator (Motor stall)
- DTC C2224-94: Rear-RH (Or Rear) Actuator (Abnormal Motor Operation)
- DTC C2240-77: Unknown Actuator State
- DTC C2244-96: EPB Incomplete Operation
- DTC C2380-01: ABS/TCS/ESP Valve Error
- DTC C2402-01: Motor Electrical
- DTC C2404-01: Servo Motor Circuit
- DTC C2405-01: Motor Encoder Fault (Current Sensor Off-Set Error)
- DTC C2405-1C: Motor Encoder Fault (Encoder Sensor Power Fault)
- DTC C2405-27: Motor Encoder Fault
- DTC C2416-11: Motor Short Or Open - LH (Short To Ground)
- DTC C2416-12: Motor Short Or Open - LH (Short To Battery)
- DTC C2416-13: Motor Short Or Open - LH (open)
- DTC C2416-71: Motor Short Or Open - LH (stuck)
- DTC C2417-11: Motor Short Or Open - RH (Short To Ground)
- DTC C2417-12: Motor Short Or Open - RH (Short To Battery)
- DTC C2417-13: Motor Short Or Open - RH (open)
- DTC C2417-71: Motor Short Or Open - RH (Stuck)
- DTC C2418-77: Motor Stall - LH
- DTC C2419-77: Motor Stall - RH
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.