Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO R/T PLUS, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 42 (6.2L - DTCS P0443 TO P058A)
2023 Dodge and Ram Durango R/T Plus, AWD
Section 42 (6.2L - DTCS P0443 To P058A)
2023 Dodge and Ram Durango R/T Plus, AWDSECTION Section 42 (6.2L - DTCS P0443 To P058A)
WARNING: This page is about a different variant/trim than selected.
- DTC Troubleshooting
- P0443-EVAP Purge Solenoid Circuit
- P0452-EVAP Pressure Switch Stuck Closed
- P0455-EVAP System Large Leak
- P0456-EVAP System Small Leak
- P0457-EVAP System - Loose Fuel Cap
- P0461-Fuel Level Sensor 1 Performance
- P0462-Fuel Level Sensor 1 Circuit Low
- P0463-Fuel Level Sensor 1 Circuit High
- P0480-Cooling Fan 1 Control Circuit/Open
- P04FC-Crankcase Ventilation System Performance
- P0501-Vehicle Speed Sensor 1 Performance
- P0506-Idle Speed Performance Lower Than Expected
- P0507-Idle Speed Performance Higher Than Expected
- P050B-Cold Start Ignition Timing Performance
- P0513-Invalid Skim Key
- P051C-Crankcase Pressure Sensor Circuit Low
- P051D-Crankcase Pressure Sensor Circuit High
- P0520-Engine Oil Pressure Sensor Circuit
- P0521-Engine Oil Pressure Sensor Performance
- P0522-Engine Oil Pressure Sensor Circuit Low
- P0523-Engine Oil Pressure Sensor Circuit High
- P0532-A/C Pressure Sensor Circuit Low
- P0533-A/C Pressure Sensor Circuit High
- P0562-Battery/System Voltage Low
- P0563-Battery/System Voltage High
- P057B-Brake Pedal Position Sensor "A" Circuit Performance
- P057C-Brake Pedal Position Sensor Circuit Low
- P057D-Brake Pedal Position Sensor Circuit High
- P0585-Speed Control Switch 1/2 Correlation
- P058A-Battery Monitor Module Performance
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.