Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPPOWER ROOF SYSTEM
2006 Chevrolet SSR Automatic
Power Roof System
2006 Chevrolet SSR AutomaticSECTION Power Roof System
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Visual Identification
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Diagnostic Starting Point - Roof
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC B1296
- DTC B1300
- DTC B1306
- DTC B1310
- DTC B1311
- DTC B1323
- DTC B1517
- DTC B1518
- DTC B3602
- DTC B3665
- DTC B3666
- DTC B3667
- DTC B3674
- DTC B3675
- DTC B3676
- DTC B3677
- DTC B3681
- DTC B3682
- DTC B3683
- DTC B3685
- Symptoms - Roof
- Power Folding Top Inoperative
- Repair Instructions
- Body Accessory Compartment Replacement - Rear
- Folding Top Latch Replacement - Side
- Folding Top Latch Adjustment - Center
- Folding Top Latch Replacement - Center
- Folding Top Latch Adjustment - Rear
- Folding Top Latch Replacement - Rear
- Folding Top Latch Cable Replacement - Rear
- Folding Top Latch Cable Adjustment - Rear
- Folding Top Latch Adjustment - Rear Upper
- Folding Top Latch Replacement - Rear Upper
- Folding Top Panel Latch Striker Replacement - Front
- Folding Top Strikers Replacement - Rear Upper
- Folding Top Stowage Compartment Lid Latch Replace
- Folding Top Stowage Compartment Lid Latch Seal Replacement
- Folding Top Stowage Compartment Lid Striker
- Folding Top Stowage Compartment Lid Hydraulic Cylinder Extension Panel Replacement
- Folding Top Stowage Compartment Lid Hydraulic Cylinder Replacement
- Folding Top Stowage Compartment Latch Hydraulic Cylinder Replacement
- Power Folding Top - Adding Fluid
- Folding Top Pump with Motor Replacement
- Folding Top Hydraulic System Bleeding Procedure
- Folding Top Hydraulic Cylinder Replacement
- Folding Top Hydraulic Cylinder Pivot Pin Replacement
- Folding Top Replacement
- Folding Top Rear Window Replacement
- Folding Top Side Rail Assembly Replacement
- Folding Top Stowage Compartment Lid Replacement
- Folding Top Stowage Compartment Lid Extension Panel Replacement
- Folding Top Stowage Compartment Lid Extension Panel Hinge
- Folding Top Stowage Compartment Lid Hinge Seal Replacement
- Folding Top Stowage Compartment Lid Hinge Replace
- Folding Top Stowage Compartment Lid Release Mech
- Folding Top Stowage Compartment Lid Lock Pillar Muckets Replacement
- Folding Top Stowage Compartment Lid Lock Pillar Drain Cups Replacement
- Folding Top Lift Assist Strut Replacement
- Folding Top Control Module Replacement
- Folding Top Panel Replacement - Front
- Folding Top Panel Adjustment - Front
- Folding Top Panel Replacement - Rear
- Folding Top Panel Adjustment - Rear
- Folding Top Hydraulic Cylinder Hose Replacement - All
- Folding Top Rear Panel Weatherstrip Replacement - Lower
- Folding Top Weatherstrip Retainer Replacement - Side Front
- Folding Top Front Panel Weatherstrip Replacement
- Folding Top Rear Panel Weatherstrip Retainer Replacement - Side
- Folding Top Rear Panel Weatherstrip Replacement - Side
- Folding Top Stowage Compartment Lid Extension Panel Weatherstrip Replacement - Front/Rear
- Folding Top Stowage Compartment Lid Weatherstrip Replacement
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.