SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPPOWER ROOF SYSTEMVISUAL IDENTIFICATIONFOLDING TOP DISASSEMBLED VIEW
2006 Chevrolet SSR Automatic

Folding Top Disassembled View

2006 Chevrolet SSR AutomaticSECTION Folding Top Disassembled View
Fig 1: Roof Panel and Lift Mechanism Disassembled View
GM1372322Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Weatherstrip Assembly - Front Panel
2 Retainer - Front Panel Seal Assembly RH
3 Panel Assembly - RF Front
4 Seal - Lock Pillar Glass Run Channel - RH
5 Retainer - Glass Run Channel B-Pillar RH
6 Striker Assembly - Panel to Panel
7 Panel Assembly - RF RR
8 Window Assembly - F/Top RR
9 Weatherstrip Assembly - RR Panel
10 Latch Assembly - Panel LH
11 Rail Assembly - Side LH
12 Capture Assembly - Top Stack Down - LH
13 Assembly - Alignment Pin LH
Fig 2: Back Seat Body Panel Disassembled View
GM1372318Courtesy of GENERAL MOTORS CORP.
Callout Component Name
14 Bin Assembly - Bulkhead
15 Module Assembly - RF Retractable
16 Lid - Bulkhead Bin
17 Front Bulkhead Assembly - Primed
18 Acoustic Insulation - Front Bulkhead
19 Bracket Assembly - Front Bulkhead Locator LH
20 Spacer Bulkhead - LH
21 Floor Bracket Front Bulkhead
22 Base Speaker - RDO 3.5 Inch
Fig 3: Stowage Lid Hall Effect Sensor Disassembled View
GM1372324Courtesy of GENERAL MOTORS CORP.
Callout Component Name
23 Cylinder - Tonneau Latch
Fig 4: Hydraulic Pump and Hoses Disassembled View
GM1372325Courtesy of GENERAL MOTORS CORP.
Callout Component Name
24 Cylinder - Top HYD Drive RH
25 Cylinder Assembly - RF Retract PNL STOW COMPT LID LAT
26 Cylinder Assembly - RF Retract STOW COMPT CLOSEOUT PNL ACTR
27 Cylinder Assembly - RF Retract PNL STOW COMPT LID
28 Defrost Wire - Backlite
29 Hose Assembly - RF Retract PNL STOW COMPT CLSOUT PNL ACTR HYD
30 Hose Assembly - RF Retract PNL STOW COMPT LID ACTR CYL HYD
31 Hose Assembly - RF Retract PNL STOW COMPT LID LAT HYD
32 Hose Set - Top HYD Drive CYL RH
33 Hydraulic Motor Housing
34 Strap - Motor Housing Cover
35 Electro-HYD Pump Unit
36 Bracket - Hydraulic System (part is POA to hydraulic system)
Fig 5: Main Lift Cylinder Hall Effect Sensors Disassembled View
GM1372326Courtesy of GENERAL MOTORS CORP.
Callout Component Name
37 Hall Effect Sensor - Top HYD Drive Cyl
Fig 6: Stowage Lid Extension Panel Hall Effect Sensors Disassembled View
GM1372327Courtesy of GENERAL MOTORS CORP.
Callout Component Name
38 Hall Sensor - Flipper Door Cylinder
Fig 7: Stowage Lid and Extension Panel Disassembled View
GM1372329Courtesy of GENERAL MOTORS CORP.
Callout Component Name
39 Panel Assembly - Flipper Door Primed
40 Hinge Assembly - Flipper Door RH
41 Panel Assembly - Roof Tonneau (retractable roof stowage compartment lid)
42 Weatherstrip - Tonneau
43 Striker Assembly - Tonneau Latch RH
44 Closeout - Tonneau Hinge RH
45 Hinge Assembly - Tonneau/Body Attach LH
46 Latch Assembly - Tonneau LH
47 CO Closeout Tonneau Latch LH
48 Nut Plate - Bin Box Attach
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.