Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Chevrolet SSR AutomaticSECTION Installation Procedure
- Install the weatherstrip to the retainers.
- Align the seal with the retainers.
- Install the weatherstrip to the rear retainer first, then install the sides.
- Push firmly on the weatherstrip to fully seat the weatherstrip to the front folding panel retainers.
Use a trim stick or a suitable tool.
- Install the screw (1) to the underside of the front folding panel.
- Install the screws (1) to each upper rear corner of the front folding panel.
- Install the front folding panel. Refer to Folding Top Panel Replacement - Front .
- Cycle the folding top closed.
- Water test the vehicle to ensure that the weatherstrip is properly seated and no leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.