Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPPOWER ROOF SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL OUTPUT CONTROLS
2006 Chevrolet SSR Automatic
Scan Tool Output Controls
2006 Chevrolet SSR AutomaticSECTION Scan Tool Output Controls
Roof and Door Module (RDM)
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Header Latch | - | The roof/door module (RDM) actuates the header latch to the Latched position when commanded ON. The header latch will actuate to Unlatched when commanded OFF. |
| Pump Motor Direction | - | When the Open command is selected, the roof/door module (RDM) will actuate the hydraulic pump motor in the roof open rotational direction for 2 seconds. When the Close command is selected, the RDM will actuate the hydraulic pump motor in both directions. First in the roof close rotational direction for 2 seconds, then pausing for 3 additional seconds and then activating the pump in the open direction for 2 more seconds. |
| Roof System | - | The roof/door module (RDM) operates the roof system through a complete open cycle when commanded Open. When Close is commanded, the RDM operates the roof system through a complete close cycle. The roof Open and Close cycle commands can be terminated at any time by pressing the Exit or Abort key. |
| Tonneau Latch | - | The roof/door module (RDM) actuates the tonneau latch to the unlatched position when commanded Off. The RDM actuates the tonneau latch to the latched position when commanded On. |
| Valve 1 | - | When commanded On, the roof/door module (RDM) energizes the #1 hydraulic pump solenoid valve to the open position for 5 seconds or until commanded Off. In a partially closed roof situation, the roof panels will retract to their mechanical resting position while the valve is open. |
| Valve 2 | - | When commanded On, the roof/door module (RDM) energizes the #2 hydraulic pump solenoid valve to the open position for 5 seconds or until commanded Off. In a partially closed roof situation, the roof panels will retract to their mechanical resting position while the valve is open. |
| Valve 3 | - | When commanded On, the roof/door module (RDM) energizes the #3 hydraulic pump solenoid valve to the open position for 5 seconds or until commanded Off. In a partially closed roof situation, the roof panels will retract to their mechanical resting position while the valve is open. |
| Valve 4 | - | When commanded On, the roof/door module (RDM) energizes the #4 hydraulic pump solenoid valve to the open position for 5 seconds or until commanded Off. In a partially closed roof situation, the roof panels will retract to their mechanical resting position while the valve is open. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.