Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 45 (HVAC SYSTEMS - MANUAL)
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Section 45 (HVAC Systems - Manual)
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Section 45 (HVAC Systems - Manual)
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC Table
- DTC P0532 or P0533: Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit Low Or High Voltage
- DTC P0645, P0646 or P0647: Air Conditioning (A/C) Clutch Relay Control Circuit Malfunction(s)
- Symptoms - HVAC Systems - Manual
- HVAC Compressor Clutch Does Not Engage
- HVAC Compressor Clutch Does Not Disengage
- Blower Motor Always On
- Blower Motor Inoperative
- Blower Motor Malfunction
- Too Hot in Vehicle
- Too Cold in Vehicle
- Air Delivery Improper
- Air Recirculation Malfunction
- Repair Instructions
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.