Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 45 (HVAC SYSTEMS - MANUAL)REPAIR INSTRUCTIONSHVAC CONTROLLER FACE PLATE/KNOBS/BUTTON REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Installation Procedure
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
- Press the face plate onto the HVAC control assembly until the retaining barbs are seated.
- Install the temperature and mode knobs by aligning the knob with the shaft pattern. Knobs should fit flush with the face plate. If not, remove them and rotate them 180 degrees.
- Install the A/C, rear defog, and recirculation buttons.
IMPORTANT:
The buttons are interchangeable. The proper order from left to right is: A/C, rear defog, and recirculation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.