Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL SYSTEM (DIAGNOSTICS)
2014 Subaru Outback 2.5i, Standard Trans
Vehicle Dynamics Control System (Diagnostics)
2014 Subaru Outback 2.5i, Standard TransSECTION Vehicle Dynamics Control System (Diagnostics)
- Basic Diagnostic Procedure
- Check List for Interview
- General Description
- Electrical Component Location
- Control Module I/O Signal
- Subaru Select Monitor
- Read Diagnostic Trouble Code (DTC)
- Inspection Mode
- Clear Memory Mode
- Warning Light Illumination Pattern
- List of Diagnostic Trouble Code (DTC)
- Diagnostic Procedure with Diagnostic Trouble Code (DTC)
- DTC C0021 Front Right Abs Sensor Circuit Open Or Short
- DTC C0023 Front Left Abs Sensor Circuit Open Or Short
- DTC C0025 Rear Right Abs Sensor Circuit Open Or Short
- DTC C0027 Rear Left Abs Sensor Circuit Open Or Short
- DTC C0022 Front Right Abs Sensor Signal
- DTC C0024 Front Left Abs Sensor Signal
- DTC C0026 Rear Right Abs Sensor Signal
- DTC C0028 Rear Left Abs Sensor Signal
- DTC C0031 Fr Hold Valve Malfunction
- DTC C0032 Fr Pressure Reducing Valve Malfunction
- DTC C0033 Fl Hold Valve Malfunction
- DTC C0034 Fl Pressure Reducing Valve Malfunction
- DTC C0035 RR Hold Valve Malfunction
- DTC C0036 RR Pressure Reducing Valve Malfunction
- DTC C0037 RL Hold Valve Malfunction
- DTC C0038 RL Pressure Reducing Valve Malfunction
- DTC C0061 Normal Opening Valve 1 Malfunction
- DTC C0062 Normal Opening Valve 2 Malfunction
- DTC C0063 Normal Closing Valve 1 Malfunction
- DTC C0064 Normal Closing Valve 2 Malfunction
- DTC C0041 ECM
- DTC C0041 Parameter Selection Error
- DTC C0042 Power Supply Voltage Failure
- DTC C0044 TCM Communication Circuit
- DTC C0045 TCM Malfunction
- DTC C0045 Incorrect VDC Control Module Specifications
- DTC C0046 Body Integrated Module Communication Circuit
- DTC C0047 Can Communication
- DTC C0048 Parking Brake System Communication Circuit
- DTC C0049 Cruise Controller Abnormal
- DTC C0051 Valve Relay
- DTC C0052 Motor Malfunction
- DTC C0054 BLS Off Malfunction
- DTC C0054 BLS On Malfunction
- DTC C0056 G Sensor Abnormal
- DTC C0056 G Sensor Signal
- DTC C0057 ECM Communication Circuit
- DTC C0057 ECM Control System
- DTC C0057 VDC Interrupted Due To EGI Reason
- DTC C0071 No Signal From Steering Angle Sensor
- DTC C0071 Steer Angle Sensor Op
- DTC C0072 Abnormal Yaw Rate Sensor Output
- DTC C0073 Lateral G Sensor Power/Output
- DTC C0073 Abnormal Lateral G Sensor Output
- DTC C0074 Master Cylinder Pressure Sensor Output
- DTC C0075 Wheel Cylinder Pressure Sensor Output
- DTC C0081 System Failure
- General Diagnostic Table
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.