Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2013SIENNA LE, AWDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOW CONTROL SYSTEM (DIAGNOSTIC CODES & SYMPTOM TESTS)
2013 Toyota Sienna LE, AWD
Power Window Control System (Diagnostic Codes & Symptom Tests)
2013 Toyota Sienna LE, AWDSECTION Power Window Control System (Diagnostic Codes & Symptom Tests)
- Power Window Control System
- DTC B2311: Power Window Motor Malfunction
- DTC B2312: Power Window Switch Malfunction
- DTC B2313: Glass Position Initialization Incomplete
- Symptom Tests
- Remote Up / Down Function does not Operate
- Driver Side Power Window does not Operate with Power Window Master Switch
- Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH does not Operate with Rear Power Window Switch LH
- Rear Power Window RH does not Operate with Rear Power Window Switch RH
- Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch
- Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
- Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH
- Key-off Operation Function Operates even if Operating Conditions are not Satisfied
- Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
- Jam Protection Function does not Operate
- Circuit Tests
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.