Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE
Smart Key System (Keyless Entry)
- Precaution
- Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customer Problem Analysis Check
- Diagnosis System
- DTC Check/Clear
- Registration
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Data List/Active Test
- Diagnostic Trouble Code Chart
- Fail-Safe Chart
- DTC B1242: Wireless Door Lock Tuner Circuit Malfunction
- DTC B278A: Immobilizer Power Source Charge Malfunction (VC5 GND Short)
- DTC B2784: Antenna Coil Open/Short
- DTC B2785: Communication Malfunction Between Ecu Connected By Lin
- DTC B2786: No Response From Steering Lock Ecu
- DTC B2789: No Response From Id Box
- DTC B2790: Malfunction Of Id-Box (EEP ROM Problem)
- DTC B2791: Communication Failure Between EFI Ecu
- DTC B2799: Immobilizer Malfunction
- Key Warning Light Circuit
- Id Code Box Power Source Circuit
- Certification Ecu Power Source Circuit
- Door Oscillator Circuit
- Touch Sensor Circuit
- Lock Switch Circuit
- Antenna Circuit
- Luggage Compartment Oscillator Circuit
- Cabin Oscillator Circuit
- Luggage Compartment Open Switch Circuit
- On-Vehicle Inspection
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
