2005 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE

DTC Check/Clear

  1. CHECK DTC 
    1. Connect the hand-held tester to the DLC3.
    2. Turn the engine switch on (IG).
    3. Read the DTCs by following the directions on the tester screen.

      HINT:

      Refer to the hand-held tester operator's manual for further details.

      Fig 1: Connecting Hand Held Tester To DLC3
      G02977086Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CLEAR DTC 
    1. Connect the hand-held tester to the DTC3.
    2. Turn the engine switch on (IG).
    3. Erase the DTCs by following the directions on the tester screen.

      HINT:

      Refer to the hand-held tester operator's manual for further details.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.