Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE
Inspection Procedure
- INSPECT ID CODE BOX
- Disconnect the D29 ID code box connector.
- Measure the voltage according to the value (s) in the table below.
Standard:
ID CODE BOX VOLTAGETester Connection Condition Specified Condition D29-1 (MPXB) - Body ground Always 10 to 14 V - Measure the resistance according to the value (s) in the table below.
Standard:
ID CODE BOX RESISTANCETester Connection Condition Specified Condition D29-8 (GND) - Body ground Always Below 1 Ω
- NG : REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR
- OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
