2005 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE

How To Proceed With Troubleshooting

HINT:

  • Use this procedure to troubleshoot the smart key system.
  • The hand-held tester can be used in steps  3,  4,  5 and  7.
  • When troubleshooting the smart key system using the hand-held tester with the engine switch off, connect the hand-held tester to the vehicle and repeat turning any of the courtesy light switches on and off until communication between the tester and the vehicle begins (the interval ON and OFF should be less than 1.5 sec).
  1. VEHICLE BROUGHT TO WORKSHOP 
    1. NEXT : Go to next step. 
  2. CUSTOMER PROBLEM ANALYSIS CHECK  
    1. Confirm problem symptoms.
    1. NEXT : Go to next step. 
  3. CHECK MULTIPLEX COMMUNICATION SYSTEM (SEE  DTC CHECK/CLEAR  ) 
    1. Check for DTCs.

      HINT:

      This system uses multiplex communication. Check for DTCs for the multiplex communication system before performing the troubleshooting.

      DTC OUTPUT

      DTC is not output. A
      DTC is output. B
    1. B : GO TO MULTIPLEX COMMUNICATION SYSTEM (SEE  HOW TO PROCEED WITH TROUBLESHOOTING  ) 
    2. A : Go to next step. 
  4. CHECK DTC (SEE  DTC CHECK/CLEAR  ) 
    1. Check for DTCs.
      1. Record the DTCs.
    2. Clear the DTCs.

      HINT:

      After DTCs are all cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).

    3. Recheck for DTCs.
      1. Simulate the malfunction and check if the DTCs are output again.
        DTC OUTPUT

        DTC is output. A
        DTC is not output. B
        DTCs are not output, and the malfunction cannot be simulated or checked. C
    1. B : Go to step   10 
    2. C : SYMPTOM SIMULATION (SEE  HOW TO PROCEED WITH TROUBLESHOOTING  ) 
    3. A : Go to next step. 
  5. DIAGNOSTIC TROUBLE CODE CHART  
    1. NEXT : Go to next step. 
  6. CIRCUIT INSPECTION (SEE  DTC B1242 WIRELESS DOOR LOCK TUNER CIRCUIT MALFUNCTION   TO  LUGGAGE COMPARTMENT OPEN SWITCH CIRCUIT  ) 
    1. NEXT : Go to next step. 
  7. OVERALL ANALYSIS AND TROUBLESHOOTING 
    1. DATA LIST/ACTIVE TEST 
      1. Inspection with the hand-held tester (DATA LIST/ACTIVE TEST)
    2. TERMINALS OF ECU 
    3. ON-VEHICLE INSPECTION 
    1. NEXT : Go to next step. 
  8. ADJUST, REPAIR OR REPLACE 
    1. NEXT : Go to next step. 
  9. CONFIRMATION TEST 
    1. NEXT: END 
  10. PROBLEM SYMPTOMS TABLE  
    1. NEXT : Go to next step. 
  11. ADJUST, REPAIR OR REPLACE 
    1. NEXT : Go to next step. 
  12. CONFIRMATION TEST 
    1. NEXT: END 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.