Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Section 422 (Power Window Control System - Diagnostics)
WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
- How To Proceed With Troubleshooting
- Customer Problem Analysis Check
- Pre-Check
- Location
- Problem Symptoms Table
- Auto Up/Down Function Does Not Operate
- Remote Up/Down Function Does Not Operate
- Manual Up/Down Function Does Not Operate (Driver Side)
- Manual Up/Down Function Does Not Operate (Passenger Side)
- Manual Up/Down Operation Function Does Not Operate (Rear LH)
- Manual Up/Down Operation Function Does Not Operate (Rear RH)
- Power Windows Do Not Operate At All
- Door Glass Goes Down During Auto Up Operation
- Diagnostic Trouble Code Chart
- Terminals Of Ecu
- DTC B1241 Body Ecu Switch Circuit Diagnosis
- DTC B2221 Jam Protection Pulse Sensor Circuit On Back Door
- Manual Up/Down Function Does Not Operate
- Manual Up/Down Function Via Back Door Lock Key Cylinder Does Not Operate
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
