Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Section 422 (Power Window Control System - Diagnostics): Pre-Check
WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
- Check Window Lock Switch
- Check that operation of the door glasses except for the driver side door glass, the back door glass and the sliding roof is disabled when the window lock switch of the power window master switch is pressed.
- Check that the door glasses, the back door glass and the sliding roof can be operated when the window lock switch is pressed again.
- Check Manual Up/Down Function
- Check that the AUTO switch of the master switch can operate the door glass as follows.
Standard:
- Check that each power window switch can operate each door glass as follows.
Standard:
- Check that the AUTO switch of the master switch can operate the door glass as follows.
- Check Auto Up/Down Function
- Check that the AUTO switch of the master switch can operate the door glass as follows.
Standard:
- Check that the AUTO switch of the master switch can operate the door glass as follows.
- Check Remote Up/Down Function
- Check that the power window master switch can operate the door glasses other than the driver side door glass.
Standard:
- Check that the power window master switch can operate the door glasses other than the driver side door glass.
- Check Power Window Operation Function After Ignition Off
- When both of the following conditions are fulfilled, check that the door glasses, the back door glass and the sliding roof can be operated even after the ignition switch is turned OFF:
- Within 45 seconds after the ignition switch is turned switch is turned OFF
- The driver side door is closed
- When both of the following conditions are fulfilled, check that the door glasses, the back door glass and the sliding roof can be operated even after the ignition switch is turned OFF:
- Check Jam Protection Function (Driver Side) NOTE: The jam protection function prevents any part of your body from getting caught by accident between the door frame and the door glass during power window operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
