Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Inspection Procedure
WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
- Check Manual Up/Down Function (Driver Side)
- Check that the door glass can be operate manually.
- NG: Another Problem (See MANUAL UP/DOWN FUNCTION DOES NOT OPERATE (DRIVER SIDE) )
- OK: Go To Next Step
- Check Power Window Regulator Master Switch Assy
- Turn the ignition switch ON.
- Operate the power window switch at the driver side.
- Check the blinking pattern of the illumination as shown in the illustration.
- If the switch indicates (1), proceed to A.
- If the switch indicates (2) or (3), proceed to B.
- If the switch indicates normal, proceed to C.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- A: Go To Next Step
- B: Go To Step 4
- C: Replace Power Window Regulator Master Switch Assy
- Reset Power Window Regulator Motor (Driver Side)
- Turn the ignition switch ON.
- Open the door glass.
- Pull up the power window switch for 2 notches until the door glass closes.
- Check that the AUTO UP/DOWN function operates completely.
- OK: END
- NG: Go To Next Step
- Check Harness And Connector (Master Switch >--< Motor)
- Disconnect the D17 master switch connector.
- Disconnect the P12 power window motor connector (driver side).
- Check the continuity between the wire harness side connectors.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard:
- OK: Replace Power Window Regulator Motor Assy LH (Driver Side)
- NG: Repair Or Replace Harness And Connector
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
