Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Inspection Procedure
WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
- Check Auto Up/Down Function
- Check that the AUTO UP/DOWN function can be operated.
- OK: Go to Next Step
- NG: Another Problem (See AUTO UP/DOWN FUNCTION DOES NOT OPERATE )
- Check Power Window Lock Switch
- Turn the window lock switch OFF and check that the remote UP/DOWN function operates.
- OK: END
- NG: Go To Next Step
- Check Manual Up/Down Function
- Check that each door glass can be operated via each door switch.
- If any door glass does not operate, proceed to NG.
- OK: Go to Next Step
- NG: Another Problem (See PROBLEM SYMPTOMS TABLE )
- Check that each door glass can be operated via each door switch.
- Inspect Power Window Regulator Master Switch Assy NOTE: Inspect the switch with which remote function can not be operate.
- Remove the master switch.
- Check the continuity between the terminals of the master switch when the switch is operated.
Standard:
Passenger Switch
Rear RH Switch
Rear LH Switch
- OK: Repair Or Replace Harness And Connector (Master Switch >--< Each Door Switch)
- NG: Replace Power Window Regulator Master Switch Assy
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
