Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Inspection Procedure
WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
- Check Rear Wiper Operation
- Turn the ignition switch ON.
- Operate the rear wiper and turn the rear wiper switch OFF.
- Check the rear wiper stops at the retract position when the rear wiper switch is turned OFF.
- OK: Go to Next Step
- NG: Replace Rear Wiper Motor Assy
- Inspect Back Door Power Window Regulator Switch Assy
- Using the hand-held tester, read the DTC when the back power window switch is operated.
- When DTC B1287 is output, proceed to A.
- When no DTC is output, proceed to B.
- When DTC B1241 is output, proceed to C.
- A: Inspect Multiplex Communication System (See MULTIPLEX COMMUNICATION SYSTEM - DIAGNOSTICS )
- B: Inspect Back Door Power Window Regulator Switch Assy (See DTC B1241 BODY ECU SWITCH CIRCUIT DIAGNOSIS )
- OK: Go to Next Step
- Using the hand-held tester, read the DTC when the back power window switch is operated.
- Read Value Of Hand-Held Tester
- Check the condition of the retract switch using the data list.
Standard:
Data list for back door ECU:
BACK DOOR ECU DATA LISTMeasurement Item Label Parameter Wiper Retract Switch Wiper Rtrct Sw On - Ok: Go To Next Step
- NG: Go To Step 6
- Check the condition of the retract switch using the data list.
- Check Harness And Connector (Back Door ECU >--< Power Window Motor)
- Disconnect The B9 Back Door ECU Connector.
- Disconnect The B11 Motor Connector.
- Check The Continuity Between The Wire Harness Side Connectors.
Standard:
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- OK: Go to Next Step
- NG: Repair Or Replace Harness And Connector
- Inspect Power Window Regulator Motor Assy LH (Back Door)
- Remove the motor.
- Apply battery voltage between the motor terminals and check that the motor rotates smoothly.
Standard:
- OK: Check And Replace Multiplex Network Door ECU Back
- NG: Replace Power Window Regulator Motor Assy LH (Back Door)
- Check Harness And Connector (Back Door ECU >--< Rear Wiper Motor)
- Disconnect the B9 back door ECU connector.
- Disconnect the R23 rear wiper motor connector.
- Check the continuity between the wire harness side connectors.
Standard:
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- OK: Replace Rear Wiper Motor Assy
- NG: Repair Or Replace Harness And Connector
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
