Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
How To Proceed With Troubleshooting
WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Troubleshoot in accordance with the procedures in this article.
- Vehicle Brought To Workshop
- Customer Problem Analysis Check And Symptom Check (See Page CUSTOMER PROBLEM ANALYSIS CHECK )
- (See PROBLEM SYMPTOMS TABLE )
- Perform Troubleshooting
- (See PRE-CHECK )
- Circuit inspection (See CIRCUIT DESCRIPTION for related symptom under PROBLEM SYMPTOMS TABLE )
- Adjust, Repair Or Replace
- Reset Power Window Motor
- If any of the power window switch illuminations is blinking after repair, reset the power window.
- Turn the ignition switch ON.
- Open the driver side door glass.
- Pull up the AUTO switch fully of the power window master switch until the door glass closes.
- Check that the AUTO UP/DOWN function operates completely.
- END
- If any of the power window switch illuminations is blinking after repair, reset the power window.
NOTE:
Troubleshoot in accordance with the procedures on the following pages.
- Vehicle Brought To Workshop
- Customer Problem Analysis Check And Symptom Check (See CUSTOMER PROBLEM ANALYSIS CHECK )
- Diagnostic Trouble Code Check (See DIAGNOSTIC TROUBLE CODE CHART )
- Check for DTCs and make a note of the code that is output.
- Delete the DTC.
- Check if the DTC will be output once again when the problem symptom is simulated based on the noted code.
- With an output of the code, proceed to A.
- Without an output of the code, proceed to B.
- A: Go to step 5
- B: Go to Next Step
- Problem Symptoms Table (See PROBLEM SYMPTOMS TABLE )
- Perform Troubleshooting
- (See PRE-CHECK )
- (See TERMINALS OF ECU )
- Circuit inspection (See INSPECTION PROCEDURE - INSPECTION PROCEDURE )
- Adjust, Repair Or Replace
- Reset Power Window Motor
- Turn the ignition switch ON.
- Open the back door glass.
- Push down the back door power window switch until the door glass is fully closed, and hold the switch 1 second more even after the door glass is fully closed.
- Check that the AUTO UP/DOWN function operates completely.
- END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
