Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Climate Control System
- Climate Control
- Specifications
- Description & Operation
- Air Distribution And Filtering
- Heating And Ventilation
- Air Conditioning
- Control Components
- Component Location
- Overview
- ATC Module
- Compressor Solenoid Valve
- Refrigerant Pressure Sensor
- Evaporator Temperature Sensor
- Cabin Temperature Sensor
- Cabin Humidity Sensor
- Ambient Air Temperature Sensor
- SUNLOAD Sensor
- Pollution Sensor
- Control Diagram
- Principles Of Operation
- Intake Air Control - Single Zone Manual System
- Intake Air Control - Dual Zone Automatic System
- Intake Air Control - Dual Zone Automatic System With Pollution Sensor
- Air Temperature Control - Single Zone Manual System
- Air Temperature Control - Dual Zone Automatic System
- Blower Motor Control - Single Zone Manual System
- Blower Motor Control - Dual Zone Automatic System
- Air Distribution Control - Single Zone Manual System
- Air Distribution Control - Dual Zone Automatic System
- Econ - Single Zone Manual System
- Econ - Dual Zone Automatic System
- Programmed Defrost
- Windshield Heater
- Rear Window Heater
- Exterior Mirror Heaters
- Seat Heaters
- Removal And Installation
- Blower Motor
- Blower Motor Resistor
- FOOTWELL Vent/Duct Blend Door Actuator
- Climate Control Assembly
- Driver Side Register
- Passenger Side Register
- Pollen Filter
- RECIRCULATION Blend Door Actuator
- Plenum Chamber
- Thermostatic Expansion Valve
- Evaporator
- Evaporator Temperature Sensor
- Heater Core
- Condenser
- Ambient Air Temperature Sensor
- Air Conditioning (A/C) Compressor
- Heater Core And Evaporator Core Housing
- Air Conditioning (A/C) Pressure Transducer
- Temperature Blend Door Actuator LH
- Temperature Blend Door Actuator RH
- Defrost Vent/Register Blend Door Actuator
- Ambient Air Quality Sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
