Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Component Location
| Item Number | Description |
|---|---|
| 1 | Refrigerant pressure sensor |
| 2 | Cabin humidity sensor (if fitted) |
| 3 | Air Conditioning (A/C) compressor (i6 shown) |
| 4 | Engine Coolant Temperature (ECT) sensor |
| 5 | Ambient air temperature sensor |
| 6 | Air intake stepper motor |
| 7 | Pollution sensor (if fitted) |
| 8 | Windshield distribution (defrost) stepper motor |
| 9 | Right Hand (RH) temperature blend stepper motor |
| 10 | Sunload sensor |
| 11 | Cabin temperature sensor |
| 12 | Automatic Temperature Control (ATC) module |
| 13 | Evaporator temperature sensor |
| 14 | Left Hand (LH) temperature blend stepper motor |
| 15 | Blower motor control module |
| 16 | Face/feet distribution stepper motor |
| 17 | Blower motor |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
