2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE

Refrigerant Pressure Sensor

Refrigerant Pressure Sensor 

GJ0009839Courtesy of JAGUAR CARS, INC.

The refrigerant pressure sensor provides the ECM with a pressure input from the high pressure side of the refrigerant system. The pressure sensor is located in the refrigerant line between the condenser and the thermostatic expansion valve.

The ECM supplies a 5 V reference feed to the pressure sensor and receives a return signal voltage, between 0 V and 5 V, related to system pressure. The ECM uses the signal from the sensor to protect the refrigerant system from extremes of pressure.

If the pressure within the refrigerant system exceeds the minimum or maximum pressure limits, the ECM will;

  • disable the A/C compressor (TD4 vehicles)
  • reduce A/C compressor displacement (i6 vehicles).

If a reduction in A/C compressor displacement fails to bring the system back into it's optimum pressure range, the i6 ECM will disable the A/C compressor.

The ECM constantly sends a refrigerant system pressure signal to the ATC module. The signal is transmitted from the ECM to the Central Junction Box (CJB) over the high speed CAN bus. The CJB acts as a gateway and provides the pressure signal to the ATC module over the medium speed CAN bus.

If the pressure within the refrigerant system rises above its maximum pressure limit, the ATC module will increase the amount of recirculated air entering the cabin. This helps lower the pressure within the refrigerant system and thus helps to avoid having to disable the A/C compressor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.