Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Control Diagram
NOTE:
A
= Hardwired; D
= High Speed CAN bus; N
= Medium Speed CAN bus; O
= LIN bus
| Item Number | Description |
|---|---|
| 1 | Battery |
| 2 | Blower motor |
| 3 | LH temperature blend stepper motor |
| 4 | Windshield distribution (defrost) stepper motor |
| 5 | Pollution sensor |
| 6 | Cabin humidity sensor |
| 7 | Air intake stepper motor |
| 8 | RH temperature blend stepper motor |
| 9 | Face/feet distribution stepper motor |
| 10 | Ambient air temperature sensor |
| 11 | A/C compressor solenoid - i6 only |
| 12 | ECT sensor |
| 13 | Refrigerant pressure sensor |
| 14 | Cabin temperature sensor |
| 15 | Evaporator temperature sensor |
| 16 | ECM |
| 17 | ATC module |
| 18 | Fuse 27, CJB |
| 19 | Blower motor control module |
| 20 | Sunload sensor |
| 21 | Fusible link 17, BJB |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
