2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE

Climate Control: Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft
A/C compressor refrigerant line connections 24 18
A/C condenser refrigerant line connections 10 7
Compressor lower support bracket - 3.2 Petrol 25 18
Compressor upper support bracket - 3.2 Petrol:     
M10 45 33
M8 25 18
M6 10 7
Compressor mounting bolts - All engines 25  
Condenser core bolts 10 7
Heater core and evaporator core housing bolts 7 6
Heater housing to bulkhead Torx bolts 7 6
Pressure transducer 8 6
Thermostatic expansion valve bolts 4 3
Thermostatic expansion valve nut 9 7
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.