2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE

Cabin Humidity Sensor

GJ0021352Courtesy of JAGUAR CARS, INC.

The cabin humidity sensor is located within the interior mirror and comprises 3 individual elements:

  • A humidity sensor
  • An air temperature sensor
  • A windshield glass temperature sensor.
NOTE: The cabin humidity sensor is an optional fit only.

The readings from these 3 sensors combine to reduce the risk of misting on the windshield.

The humidity sensor element is contained behind a nylon mesh cover. The sensor comprises an element made up of film capacitors on different substrates. The dielectric is a polymer which absorbs or releases water proportional to the humidity of the air being drawn through the sensor. This causes a change in the capacitance of the sensor.

Humidity within the cabin is controlled by raising or lowering the temperature of the evaporator. An increase in evaporator temperature increases the moisture content of the air in the cabin. Lowering the evaporator temperature reduces the moisture content of the air in the cabin.

The capacitance of the sensor, together with both temperature values, are provided as LIN bus messages to the ATC module. The ATC module uses these signals to calculate the dew point of the air at the windshield. When the temperature of the windshield glass reaches or falls below this value, misting is likely to occur. In this instance, the ATC module will;

  • Raise the temperature of the air leaving the heater assembly
  • Adjust the position of the windshield distribution (defrost) stepper motor
  • Adjust the position of the air intake stepper motor
  • Reduce A/C compressor displacement (i6 only)
  • Power the windshield heater elements (if fitted).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.