Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jaguar XFRFACTORY OEM SERVICE PROCEDURE
Section 12 (Climate Control)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 Jaguar XFR, 2012 Jaguar XF, 2011 Jaguar XFR, 2011 Jaguar XF, and 2010 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.
- Climate Control
- Specifications
- Description And Operation
- Air Distribution And Filtering
- Heating And Ventilation
- Air Conditioning
- Control Components
- Component Location
- Overview
- System Operation And Component Description
- Notes
- Air Inlet Control
- Air Temperature Control
- Blower Control
- Air Distribution Control
- A/C Compressor Control
- A/C Compressor Torque
- Cooling Fan Control
- Programmed Defrost
- Rear Window Heater
- Windshield Heater (Where Fitted)
- Exterior Mirror Heaters
- Seat Heaters (Where Fitted)
- Steering Wheel Heater
- ATC Module
- A/C Compressor Solenoid Valve
- Refrigerant Pressure Sensor
- Evaporator Temperature Sensor
- Humidity and Temperature Sensor
- Ambient Air Temperature Sensor
- Sunload Sensor
- Pollution Sensor (Where Fitted)
- Removal And Installation
- Ambient Air Temperature Sensor
- Blower Motor
- Blower Motor Control Module
- Center Registers
- Climate Control Assembly
- Climate Control Module
- Defrost Vent/Register Blend Door Actuator
- Desiccant Bag
- Driver Side Register
- Evaporator
- Floor Console Register
- FOOTWELL Vent/Duct Blend Door Actuator
- Heater Core
- Heater Core And Evaporator Core Housing
- Instrument Panel Register Trim Panel
- In-Vehicle Temperature Sensor
- Passenger Side Register
- Pollen Filter
- RECIRCULATION Blend Door Actuator
- SUNLOAD Sensor
- Thermostatic Expansion Valve
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
