Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Jaguar XFRFACTORY OEM SERVICE PROCEDURE
Climate Control: Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 Jaguar XFR, 2012 Jaguar XF, 2011 Jaguar XFR, 2011 Jaguar XF, and 2010 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Blower motor control module retaining bolts | 1 | - | 9 |
| Foot duct to cross car beam retaining bolt | 5 | - | 44 |
| Climate control assembly to cross car beam retaining bolts | 9 | - | 80 |
| Climate control module retaining bolts | 1 | - | 9 |
| Defrost vent/register blend door actuator retaining bolts | 1 | - | 9 |
| Evaporator pipe bracket retaining bolts | 1 | - | 9 |
| Evaporator housing retaining bolts | 1 | - | 9 |
| Footwell vent/duct blend door actuator retaining bolt | 1 | - | 9 |
| Heater core housing retaining bolts | 2 | - | 18 |
| Sunload sensor retaining bolt | 2 | - | 18 |
| Evaporator core pipes mounting bracket retaining bolts | 1 | - | 9 |
| Evaporator core pipes to thermostatic expansion valve retaining bolt | 5 | - | 44 |
| Thermostatic expansion valve retaining bolts | 3 | - | 26 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
