2014 Jaguar XFRFACTORY OEM SERVICE PROCEDURE

Control Components: Overview

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 Jaguar XFR, 2012 Jaguar XF, 2011 Jaguar XFR, 2011 Jaguar XF, and 2010 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.

The climate control system is controlled by the automatic temperature control (ATC) module. It controls the heating and ventilation system and the air conditioning (A/C) system to regulate the temperature, volume and distribution of air into the passenger compartment. The system is a fully automatic dual zone system capable of maintaining individual temperature levels selected for the left-hand (LH) and right-hand (RH) sides of the passenger compartment, up to a maximum differential of approximately 3Β°C (5.4Β°F). Manual overrides for the system include inlet air source, blower speed and air distribution. These selections can be made using either the soft switches on the home and climate control screens of the touch screen display (TSD), or the switches on the integrated control panel.

The automatic temperature control (ATC) module also controls:

  • The rear window heater.
  • The windshield heater (where fitted).
  • The exterior mirror heaters.
  • The seat heaters (where fitted).
  • The steering wheel heater.
GJ0011684Courtesy of JAGUAR CARS, INC.
GJ0011685Courtesy of JAGUAR CARS, INC.
GJ0011686Courtesy of JAGUAR CARS, INC.
Item Number Description
1 left-hand (LH) temperature switches
2 Blower switch
3 right-hand (RH) temperature switches
4 Automatic climate control switch
5 Recirculation switch
6 Rear window heater switch
7 Windshield heater switch
8 Programmed defrost switch
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.