2014 Jaguar XFRFACTORY OEM SERVICE PROCEDURE

Programmed Defrost

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 Jaguar XFR, 2012 Jaguar XF, 2011 Jaguar XFR, 2011 Jaguar XF, and 2010 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.

The programmed defrost DEF switch is located on the integrated control panel. When the switch is pressed, the automatic temperature control (ATC) module instigates the programmed defrost function. When selected, the automatic temperature control (ATC) module configures the system as follows:

  • Automatic mode off.
  • Air conditioning (A/C) on.
  • Selected temperature unchanged.
  • Air inlet set to fresh air.
  • Air distribution set to windshield.
  • Blower speed set to level 6.
  • Windshield heater (where fitted) and rear window heater on.

The programmed defrost function can be cancelled by one of the following:

  • Selecting any air distribution switch on the TSD.
  • Pressing the AUTO switch on the integrated control panel.
  • A second press of the DEF button.
  • Switching the ignition OFF.

The blower speed can be adjusted without terminating the programmed defrost function.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.