2014 Jaguar XFRFACTORY OEM SERVICE PROCEDURE

Component Location

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 Jaguar XFR, 2012 Jaguar XF, 2011 Jaguar XFR, 2011 Jaguar XF, and 2010 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: right-hand drive (RHD) vehicle shown, left-hand drive (LHD) vehicle similar.
GJ0011559Courtesy of JAGUAR CARS, INC.
Item Number Description
1 Pollution sensor
Comments:Β 
where fitted
2 Unload sensor
3 Ambient air temperature sensor
4 Windshield (Defrost) distribution stepper motor
5 Evaporator temperature sensor
6 right-hand (RH) temperature blend stepper motor
7 left-hand (LH) temperature blend stepper motor
8 Control switches
9 Humidity and temperature sensor
10 Air inlet servo motor
11 Blower
12 automatic temperature control (ATC) module
13 Blower control module
14 Face/Feet distribution stepper motor
15 Refrigerant pressure sensor
16 air conditioning (A/C) compressor solenoid valve
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.