Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM20241500 TRXREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 214 ((MEMORY SEAT MODULE (MSMD) - ELECTRICAL DIAGNOSTICS - 1500))
2024 Dodge and Ram 1500 TRX
Section 214 ((Memory Seat Module (MSMD) - Electrical Diagnostics - 1500))
2024 Dodge and Ram 1500 TRXSECTION Section 214 ((Memory Seat Module (MSMD) - Electrical Diagnostics - 1500))
WARNING: This page is about a different car, the 2023 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Code Index
- DTC Troubleshooting
- B1D5B-00-Adjustable Pedal Switch Circuit Performance
- B1D5C-23-Adjustable Pedal Switch Circuit Stuck Forward-Signal Stuck Low
- B1D5D-23-Adjustable Pedal Switch Circuit Stuck Rearward-Signal Stuck Low
- B1D5E-15-Power Seat Switch-Circuit Short To Battery Or Open
- B1D62-2A-Power Seat Switch Stuck-Stuck
- B1D67-00-Adjustable Pedal Control Circuit Performance
- B1D7B-00-Seat Horizontal Motor Control Circuit Performance
- B1D7F-00-Seat Front Vertical Motor Control Circuit Performance
- B1D83-00-Seat Rear Vertical Motor Control Circuit Performance
- B1D87-00-Seat Backrest Motor Control Circuit Performance
- B1D9B-54-Seat Horizontal Front Stop Not Learned-Missing Calibration
- B210A-84-System Voltage Low-Signal Below Allowable Range
- B210B-85-System Voltage High-Signal Above Allowable Range
- B210D-21-Battery Voltage Low-Signal Amplitude Below Minimum
- B210E-22-Battery Voltage High-Signal Amplitude Above Maximum
- B221C-42-MSM-Memory Seat Module Internal-General Memory Failure
- B222D-00-Ecu Unable To Configure-Configuration Not Learned
- B233C-00-Commanded Position Not Reachable
- U0011-00-Can Interior Bus Off Performance
- U0140-00-Lost Communication With Body Control Module
- U0199-00-Lost Communication With Driver Door Module
- Standard Procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.