Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE
Air Bag Restraint Systems
- Restraints
- Child Restraint Anchor
- Child Tether Upper Cover
- Clock Spring
- Curtain Airbag
- Driver Airbag
- Driver Airbag Trim Cover
- Front Seat Belt Buckle - Jr27 Only
- Front Seat Belt & Retractor - Jr27 Only
- Occupant Restraint Controller
- Passenger Airbag
- Rear Seat Belt Buckle - Jr27 Only
- Rear Seat Belt & Retractor - Jr27 Only
- Satellite Acceleration Sensor
- Seat Belt Cinch Bar
- Seat Belt Control Timer Module - Jr27 - Export
- Description
- Operation
- Diagnosis And Testing
- Diagnosis And Testing - Seat Belt Control Timer Module
- Notes
- Diagnostic Mode
- Detectable Faults
- SCTM Conditions
- Notes
- Both Seat Belts Locked All The Time.
- Both Seat Belts Locked With The Ignition Switch In The Off Position And The SCTM Not Timed Out.
- Both Seat Belts Lock And Unlock With The Ignition Switch On Or When The Passenger Door Ajar Switch Is Activated But Not When The Driver Door Ajar Switch Is Activated.
- Both Seat Belts Lock And Unlock With The Ignition Switch On Or When The Driver Door Ajar Switch Is Activated But Not When The Passenger Door Ajar Switch Is Activated.
- Driver Seat Belt Locked, Passenger Seat Belt Unlocked.
- Passenger Seat Belt Locked, Driver Seat Belt Unlocked.
- Diagnosis And Testing - Seat Belt Control Timer Module
- Removal
- Installation
- Seat Belt Height Adjuster
- Seat Belt - Rear Inboard
- Seat Belt - Rear Outboard
- Seat Belt & Retractor - Front Outboard
- Seat Belt & Retractor - Rear Center
- Seat Belt TENSIONER
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
