Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE
Standard Procedure - Clock Spring Centering
WARNING:
IF THE ROTATING TAPE WITHIN THE CLOCK SPRING IS NOT POSITIONED PROPERLY WITH THE STEERING WHEEL AND THE FRONT WHEELS, THE CLOCK SPRING MAY FAIL DURING USE. THE CLOCK SPRING IS CENTERED WHEN YELLOW APPEARS IN THE CENTERING WINDOW AND THE ARROW ON THE LABEL POINTS TO THE DRIVE PIN. IF THE CLOCK SPRING IS NOT CENTERED, THIS PROCEDURE MUST BE USED TO CENTER THE CLOCK SPRING. FAILURE TO DO SO COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.
- Adjust the steering wheel so that the tires are in a straight ahead position.
- Remove driver airbag from steering wheel.
- Disconnect wire connectors from back of airbag.
- Remove steering wheel.
- Depress the plastic locking pin to disengage lock mechanism.
- With lock mechanism disengaged, rotate the clock spring rotor clockwise until the rotor stops. Do not apply excessive force.
- From the end of travel, rotate the rotor three turns counterclockwise. The wires should end up at the top. Release the plastic locking pin to engage clock spring lock mechanism.
- Install steering wheel and airbag.
WARNING:
DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO DIAGNOSIS AND TESTING - AIRBAG SYSTEMΒ FIRST. FAILURE TO DO SO COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
