2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE

Clock Spring: Description

The clock spring assembly is mounted near the top of the steering column behind the steering wheel. The clock spring is used to maintain a continuous electrical circuit between the fixed instrument panel wire harness connector on the steering column and several electrical components that rotate with the steering wheel. The rotating components include the driver airbag, the horn switch and the vehicle speed control switches.

The clock spring cannot be repaired. If the clock spring is faulty, damaged or if the driver airbag has been deployed, the clock spring must be replaced.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.