2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE

Clock Spring: Removal

  1. Disconnect and isolate the battery negative remote cable.
  2. Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
  3. Remove the steering wheel. (Refer to STEERING/COLUMN/STEERING WHEEL - REMOVAL) . Carefully feed all wires over the steering wheel armature to avoid damaging wires. When replacing a deployed Driver Airbag, a new clock spring must be installed.
  4. Remove multi-function switch.
  5. Remove the clock spring by lifting the top lock housing latches up slightly to guide it over the lock housing. The clock spring cannot be serviced and must be replaced if defective, damaged or the vehicle has sustained an impact where the front airbags were deployed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.