Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clock Spring: Operation
The clock spring assembly consists of a plastic case which contains a flat, ribbon-like, electrically conductive tape that winds and unwinds like a clock spring with the steering wheel rotation. The electrically conductive tape consists of several fine gauge copper wire leads sandwiched between two narrow strips of plastic film.
Like the clock spring in a timepiece, the clock spring tape has travel limits and can be damaged by being wound too tightly. To prevent this from occurring, the clock spring is centered when it is installed on the steering column. Centering the clock spring indexes the clock spring tape to other steering components so that it can operate within its designed travel limits. However, if the clock spring is removed for service or if the steering column is disconnected from the steering gear allowing the clock spring tape to change position relative to the other steering components, it must be re-centered following completion of the service or it may be damaged. Refer to STANDARD PROCEDURE - CLOCK SPRING CENTERINGΒ .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
