Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE
Satellite Acceleration Sensor: Installation
- Position the satellite acceleration sensor (SAS) in B-pillar (electrical connector facing forward in vehicle) and install the retaining screws. Torque the screws to 7 N.m (62 in. lbs.).
- Connect the SAS electrical connector.
- Install the lower B-pillar trim. Refer to B-PILLAR LOWER TRIM .
WARNING:
DO NOT CONNECT THE BATTERY NEGATIVE CABLE REMOTE TERMINAL. REFER TO DIAGNOSIS AND TESTING - AIRBAG SYSTEMΒ FIRST. FAILURE TO DO SO COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
