Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL & STEERING COLUMN
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Steering Wheel & Steering Column
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Steering Wheel & Steering Column
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Steering Wheel Controls
- Steering Wheel Controls Inoperative
- Symptoms - Steering Wheel and Column
- Symptoms - Steering Wheel Controls
- Ignition Can/Cannot Be Turned Off with Transmission in Any Gear
- Ignition Lock Cylinder is Stuck Inside Lock Cylinder Case
- Ignition Key Cannot Be Removed from the Ignition Lock Cylinder
- Ignition Key Cannot Turn or Sticks in Any Position
- Noise in Steering Column
- Looseness in Steering Column
- Repair Instructions
- Intermediate Steering Shaft Replacement
- Steering Column Accident Damage Inspection
- Steering Column Trim Covers Replacement
- Ignition Switch Replacement
- Ignition Lock Cylinder Replacement
- Ignition Lock Cylinder Case Replacement
- Ignition Lock Cylinder Solenoid Replacement
- Multifunction, Turn Signal Switch Replacement
- Steering Wheel Control Switch Assembly Replacement
- Steering Wheel Replacement
- Steering Wheel Shroud Replacement
- Steering Column Replacement
- Steering Column Jacket Replacement
- Inflatable Restraint Steering Wheel Module Coil Centering
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.