Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLE
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30
Instrument Panel System Displays, Gauges And Console
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Instrument Panel System Displays, Gauges And Console
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Diagnostic Starting Point - Instrument Panel, Gages and Console
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC B1372
- DTC B2961
- DTC P0381
- DTC P0461
- DTC P0462
- DTC P0463
- DTC P0464
- DTC P0522
- DTC P0523
- DTC P2066
- DTC P2067
- DTC P2068
- Symptoms - Instrument Panel, Gages and Console
- Instrument Cluster Inoperative
- Engine Oil Pressure Gage Inaccurate or Inoperative
- Fuel Gage Inaccurate or Inoperative (Single Tank)
- Fuel Gage Inaccurate or Inoperative (Dual Tank)
- Instrument Panel Cluster (IPC) Gages Inoperative
- Change Engine Oil Indicator Always On
- Change Engine Oil Indicator Inoperative
- Low Engine Oil Level Indicator Always On
- Low Fuel Indicator Inoperative
- Water-in-Fuel Lamp Always On
- Water-in-Fuel Lamp Inoperative
- Chime Always On
- Chime Inoperative
- Repair Instructions
- Multifunction Alarm Module Replacement
- Instrument Panel (I/P) Extension Trim Plate Replacement
- Instrument Panel (I/P) Extension Replacement
- Knee Bolster Replacement - Right
- Knee Bolster Bracket Replacement - Right
- Knee Bolster Replacement - Left
- Knee Bolster Bracket Replacement - Left
- Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster
- Compartment Replacement - Instrument Panel (I/P)
- Latch Replacement - Instrument Panel (I/P) Compartment
- Trim Pad Replacement - Instrument Panel (I/P) Upper
- Trim Pad Replacement - Instrument Panel (I/P)
- Instrument Panel Cluster (IPC) Replacement
- Instrument Panel (I/P) Carrier Replacement
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.