Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLEREPAIR INSTRUCTIONSKNEE BOLSTER REPLACEMENT - LEFTINSTALLATION PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30
Installation Procedure
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Installation Procedure
- Position the I/P driver knee bolster panel to the vehicle.
- Align the retainers on the I/P driver knee bolster panel (1) with the slots at the top of the knee bolster bracket.
- Press towards the front of the vehicle in order to engage the I/P driver knee bolster panel (1) retainers.
- Install the knee bolster panel (1) bolts (2).
Tighten: Tighten the bolts to 3.5 N.m (31 lb in).
- Enable the SIR. Refer to SIR Disabling and Enabling Zone 3 in SIR.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.