Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995CAVALIER LS, 4D SEDAN, 2.2 4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 19 (AIR BAG RESTRAINT SYSTEM)
1995 Chevrolet Cavalier LS, 4D Sedan, 2.2 4
Section 19 (Air Bag Restraint System)
1995 Chevrolet Cavalier LS, 4D Sedan, 2.2 4SECTION Section 19 (Air Bag Restraint System)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Saturn SW2, 1995 Saturn SW1, 1995 Saturn SL2, 1995 Saturn SL1, and 1995 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.
- Identification
- Description & Operation
- System Operation Check
- Service Precautions
- Adjustments
- Disabling & Activating Air Bag System
- Disposal Procedures
- Post-Collision Inspection
- Removal & Installation
- Diagnosis & Testing
- Diagnostic Charts
- Sir Diagnostic System Check
- Chart A - SDM Integrity Check
- Chart B - Air Bag Warning Light Comes "On" Steady
- Chart C - Air Bag Warning Light Does Not Come "On"
- Chart D - SDM Cannot Communicate With PDT
- DTC 15 - Passenger Initiator Circuit Resistance High
- DTC 16 - Passenger Initiator Circuit Resistance Low
- DTC 17 - Passenger Initiator Circuit Open
- DTC 21 - Driver Initiator Circuit Resistance High
- DTC 22 - Driver Initiator Circuit Resistance Low
- DTC 24 - Initiator Circuit Voltage Low
- DTC 25 - Initiator Circuit Short To Ignition
- DTC 26 - Driver Initiator Circuit Open
- DTC 51 - Frontal Crash Detected
- DTC 52 - Data Area Full
- DTC 61 - Air Bag Warning Light Circuit Failure
- DTC 62 - Redundant Air Bag Warning Light Failure
- DTC 71 - Internal SDM Fault
- Post-Collision Air Bag Safety Inspection
- Wire Repair
- Torque Specifications
- Wiring Diagram
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.