Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 113 (SECURITY AND LOCKS)
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Section 113 (Security And Locks)
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Section 113 (Security And Locks)
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
- General Description
- Component Location
- Diagnostic Information and Procedures
- Power Door Lock System Symptom Diagnosis
- Power Door Lock System Operation Inspection
- Keyless Entry System Symptom Diagnosis (If Equipped)
- Keyless Entry System Operation Inspection (If Equipped)
- Door Lock Function of Keyless Start System Symptom Diagnosis (If Equipped)
- Rear End Door Opener System Symptom Diagnosis
- Rear End Door Opener System Operation Inspection
- Repair Instructions
- Front Door Lock Assembly Components
- Front Door Lock Assembly Removal and Installation
- Front Door Lock Assembly Inspection
- Power Door Lock Switch Inspection
- Door Key Cylinder Switch Inspection
- Power Door Lock Actuator Inspection
- Rear Door Lock Assembly Components
- Rear Door Lock Assembly Removal and Installation
- Rear Door Lock Assembly Inspection
- Rear End Door Lock Assembly Components (Hatchback)
- Rear End Door Lock Assembly Removal and Installation (Hatchback)
- Rear End Door Lock Assembly Inspection (Hatchback)
- Rear End Door Opener Switch Inspection (Hatchback)
- Trunk Lid Lock Assembly Components (Sedan)
- Trunk Lid Lock Assembly Removal and Installation (Sedan)
- Trunk Lid Lock Assembly Inspection (Sedan)
- Replacement of Transmitter Battery (Other than Keyless Start Model)
- Programming Transmitter Code for Keyless Entry System (Other than Keyless Start Model)
- Keyless Entry Receiver Removal and Installation (If Equipped)
- Keyless Entry Receiver and Its Circuit Inspection (If Equipped)
- Specifications
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.