Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear End Door Lock Assembly Removal and Installation (Hatchback): Installation
Reference: REAR END DOOR LOCK ASSEMBLY INSPECTION (HATCHBACK)
Reverse removal procedure to install rear end door lock assembly noting the following instruction.
- Tighten rear end door latch bolt to specified torque.
Tightening torque
Rear end door latch bolt (a): 10 N.m (1.0 kg-m, 7.5 lbf-ft)
- Adjust door latch striker so that its center aligns with the center of groove in door latch base.
Tightening torque
Rear end door striker screw (a): 23 N.m (2.3 kg-m, 17.0 lbf-ft)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.