General Diagnostic Table: Inspection

2014 Subaru Forester 2.5i, Eng CD FB25BA, Standard TransSECTION Inspection
Symptoms Note
Turn hazard lights do not illuminate < Ref. to TURN HAZARD LIGHTS DO NOT ILLUMINATE , INSPECTION, Diagnostics with Phenomenon. >
The buzzer does not sound < Ref. to THE BUZZER DOES NOT SOUND , INSPECTION, Diagnostics with Phenomenon. >
Half-stop cannot be cancelled < Ref. to HALF-STOP CANNOT BE CANCELLED , INSPECTION, Diagnostics with Phenomenon. >
Operation by the PRG driver's SW is not possible < Ref. to OPERATION BY THE PRG DRIVER'S SW IS NOT POSSIBLE , INSPECTION, Diagnostics with Phenomenon. >
Memory height SW does not function. < Ref. to CHECK MEMORY HEIGHT SW INPUT CIRCUIT , INSPECTION, Diagnostics with Phenomenon. >
PRG inner SW does not function < Ref. to PRG INNER SW DOES NOT FUNCTION , INSPECTION, Diagnostics with Phenomenon. >
PRG position cannot be memorized. < Ref. to PRG POSITION CANNOT BE MEMORIZED , INSPECTION, Diagnostics with Phenomenon. >
PRG opener button does not function < Ref. to PRG OPENER BUTTON DOES NOT FUNCTION , INSPECTION, Diagnostics with Phenomenon. >
Operation from keyless/keyless access mobile key is not possible. < Ref. to OPERATION FROM KEYLESS/KEYLESS ACCESS MOBILE KEY IS NOT POSSIBLE , INSPECTION, Diagnostics with Phenomenon. >
Check PRG driver's SW input circuit < Ref. to CHECK PRG DRIVER'S SW INPUT CIRCUIT , INSPECTION, Diagnostics with Phenomenon. >
Check PRG inner SW input circuit < Ref. to CHECK PRG INNER SW INPUT CIRCUIT , INSPECTION, Diagnostics with Phenomenon. >
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.