Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004BAJA BASE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKS
2004 Subaru Baja Base, Standard
Security And Locks
2004 Subaru Baja Base, StandardSECTION Security And Locks
- General Description
- Door Lock Control System
- Keyless Entry System
- Schematic
- Electrical Specification
- Inspection
- Symptom Chart
- Check Transmitter Battery And Function
- Check Buzzer Chirp Setting
- Check Fuse
- Check Power Supply And Ground Circuit
- Check Ignition Switch Circuit
- Check Door Switch
- Check Key Warning Switch
- Check Room Light Operation
- Check Output Signal To Integrated Module
- Check Horn Operation
- Check Hazard Light Operation
- Check Keyless Buzzer
- Security System
- Front Inner Remote
- Front Outer Handle
- Front Door Latch Assembly
- Front Door Lock Actuator
- Rear Inner Remote
- Rear Outer Handle
- Rear Door Latch Assembly
- Rear Door Lock Actuator
- Rear Gate Outer Handle
- Rear Gate Latch Assembly
- Rear Gate Latch Lock Actuator
- Trunk Lid Lock Assembly
- Trunk Lid Release Handle
- Front Hood Lock Assembly
- Remote Openers
- Ignition Key Lock
- Key Lock Cylinders
- Security Control Module
- Security Horn
- Security Horn Relay
- Interrupt Relay
- Keyless Entry Control Module
- Integrated Module
- Keyless Transmitter
- Switch Back Gate Handle
- Switch Back Gate Latch
- Tail Gate Outer Handle
- Tail Gate Latch Assembly
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.