Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004BAJA BASE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSKEYLESS ENTRY SYSTEMINSPECTIONCHECK IGNITION SWITCH CIRCUIT
2004 Subaru Baja Base, Standard
Check Ignition Switch Circuit
2004 Subaru Baja Base, StandardSECTION Check Ignition Switch Circuit
CHECKING STEPS REFERENCE
| Step | Check | Yes | No |
|---|---|---|---|
1 CHECK IGNITION SWITCH SIGNAL.
|
Is the measured value more than 10 V? | Ignition switch circuit is OK. | Check the harness for open circuits and shorts between the keyless entry control module and ignition relay. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.