Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004BAJA BASE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSKEYLESS ENTRY SYSTEMELECTRICAL SPECIFICATIONKEYLESS ENTRY CONTROL MODULE
2004 Subaru Baja Base, Standard
Keyless Entry Control Module
2004 Subaru Baja Base, StandardSECTION Keyless Entry Control Module
CONTENT, TERMINAL NO AND MEASURING CONDITION
| Content | Terminal No. | Measuring condition |
|---|---|---|
| Integrated module | 1 (OUTPUT) | 0 V is present when pressing the transmitter LOCK/ARM button. |
| Integrated module | 2 (OUTPUT) | 0 V is present when pressing the transmitter UNLOCK/DISARM button. |
| Security control module | 3 | - |
| Security control module | 4 | - |
| Door lock switch | 5 (INPUT) | 0 V is present when operating the door lock switch. |
| Ignition switch (ON) | 6 (INPUT) | Battery voltage is present when ignition switch is turned to ON. |
| Key warning switch | 7 (INPUT) | Battery voltage is present when inserting the key into the ignition switch. |
| Door unlock switch | 8 (INPUT) | 0 V is present when operating the door lock switch. |
| Trunk room light switch (Sedan), rear gate latch switch (Wagon) | 9 (INPUT) | 0 V is present when trunk lid or rear gate is open. |
| Door switch | 10 (INPUT) | 0 V is present when any door is open. |
| Ground | 11 | 0 V is constantly present. |
| Turn signal light (Left) | 12 (OUTPUT) | Battery voltage is present when pressing the transmitter UNLOCK/DISARM or LOCK/ARM button. |
| Horn relay | 13 (OUTPUT) | 0 V is present when pressing the transmitter LOCK/ARM button three times within 5 seconds. |
| Power supply | 14 | Battery voltage is constantly present. |
| Power supply (Back-up) | 15 | Battery voltage is constantly present when back-up fuse is energized. |
| Keyless buzzer | 16 (OUTPUT) | 0 V is present when pressing the transmitter UNLOCK/DISARM or LOCK/ARM button. |
| Security control module | 17 | - |
| Arm signal light (Right) | 18 (OUTPUT) | Battery voltage is present when pressing the transmitter UNLOCK/DISARM or LOCK/ARM button. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.