Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004BAJA BASE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSSECURITY CONTROL MODULEREMOVAL
2004 Subaru Baja Base, Standard
Security Control Module: Removal
2004 Subaru Baja Base, StandardSECTION Removal
- Disconnect the ground cable from battery.
- Remove front cover (A).
- Remove screws (B) and then detach center panel (C) while disconnecting connector.
- Remove two screws.NOTE: Before removing the screw, apply a few turns of butyl tape to the tip of the service tool. This prevents the screw from falling during removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.